Thunder cat cable routeing

Hey guys i recently bought a thundercat which was in bits im steadily building it up as my first project bike im up to putting the wireing loom in if anyone could send me pictures of the cable routeing as im not sure because i didnt take it out so im not sure how it goes its only this part which is stopping me from progressing and haynes manual is a load of crap it doesnt tell you at all any help would be greatly appreciated

Hi, and welcome.

Don't have any pic's, as far as I remember the wiring loom runs alongside the left hand side of the frame. There have been some engine out 'rebuilds' recently, maybe some one has taken picks of the wiring loom.

Hi and welcome. Good luck with the loom, afraid I an clueless, but as has been mentioned (above), there are a few hardy souls around the forum wat 'as taken their Cat to bits and re assembled them.
I'm confident they'll be along sometime soon and will be happy to pass on their wisdom  

Have a search on here for 'Service manual' I'm sure it's in there, I can't check mine right now I'm afraid